
Thread inserts are usually equipped with a tang, which is required for the installation and must be removed from the insert after installation.
V-COIL notch Thread Inserts do not have this tang. Therefore the removal of this tang, which must be carried out with conventional thread inserts after assembly, is no longer necessary. Instead, these inserts have small notches (driver notches) on the inside at both ends of the thread inserts. The V-COIL notch installation tool engages in these notches and securely holds the thread insert so that it can then be screwed into the holding thread.
V-COIL notch Thread Inserts (without tang) offer the same level of reliable thread reinforcement and thread repair as the well-known thread inserts type “S” and “SL”, but without the risk of losing the tang and becoming a safety hazard.
V-COIL notch offers the following advantages:
- more safety
- higher installation speed
- more flexibility
All this, and much more, is available in a practical set. This set comes in a handy plastic packaging with foam inlay.
In addition to the V-COIL notch Inserting Tool and the Thread Inserts (without tang), the set also contains two other well-known tools from the V-COIL family: the V-COIL rapid STI Twist Drill and the rapid STI Tap. All tools in the set are equipped with a ¼ inch hexagon and therefore offer maximum drive flexibility. A ¼ inch bit holder is also included.
All V-COIL notch articles are, as usual, immediately available from stock.
ALWAYS A NOTCH ABOVE.